Product Information

Extremely sharp-printing plating resist recommended for long plating cycles. This resist withstands not only most plating solutions but can be used as a solvent strippable resist with alkaline etchants.

Specifications

Curing：Depending upon plating operation, this resist should be cured at 200℉(90℃)for periods ranging from 10 to 45 minutes.

Thinners：Use 5550 Thinner

Fabrics：Stainless steel or monofilament meshes are recommended.

Stencils：Direct emulsions or indirect photographic films.

Removable After Etching：Use chlorinated solvents such as trichlorethylene, or xylol.

All technical information and recommendations published by Tsaui Mining relating to Tsaui Mining’s products are based on experience gained in field condition and detailed laboratory tests believed to be reliable.  However, Tsaui Mining cannot guarantee the finished results because Tsaui Mining exercises no control over individual operating conditions and production procedures.  The users bear sole responsibility for selecting the appropriate product for their end-use requirements.  They are also responsible for testing to determine that our product will perform as expected during the printed item's entire life-cycle from printing, post-print processing, shipment and to end-use.  This product has been specially formulated for  application as stated in the product data sheet and has not been tested for other method.  Any liability associated with the use of this product is limited to the value of the product purchased from Tsaui Mining .